Motec Systems M GPS BL User Manual

MoTeC USA GPS Part # M GPS BL Available in 10 Hz or 20 Hz. USER MANUAL Version 1.4

MoTeC USA Installation 9 Setup for M400 / M600 / M800 Wire the speed output pulse into a digital input on the ECU. For the calibration number, u

MoTeC USA Analysis 10 “i2” Analysis Math GPS data will have an inherent time lag. The sequence of delays are from receiving real-time satellite

MoTeC USA Analysis 11 The speed output pulse or variable voltage output should not be included in the “Corrected GPS” calculations. It will requ

MoTeC USA Appendix 12 Appendix GPS Engine Specifications 12-channel GPS engine. Horizontal accuracy < 1 meter at 95% Update rate of 10 Hz or 2

MoTeC USA Appendix 13 Physical Case Size: 3.95” x 2.7” x 0.9” (excluding connectors) 100 mm x 69 mm x 23 mm (excluding connectors)

MoTeC Notes 14

MoTeC USA GPS  Copyright – Motec Systems USA – 2008 The information in this document is subject to change without notice. Whi

MoTeC USA GPS 2 Contents Introduction...3 Warm Up Time...

MoTeC USA GPS 3 Introduction Thank you for purchasing a MoTeC USA GPS receiver. This user’s guide was written to help you understand how the MoT

MoTeC USA GPS 4 Status LEDs There are 4 LEDs on the front face of the unit labeled as follows: • POWER (red): Unit has power. • GPS (yellow):

MoTeC USA GPS 5 Speed Output Pulse This output is for devices that can’t accept a RS-232 serial input. It provides a 0-5 volt square wave outp

MoTeC USA Installation 6 Installation GPS Receiver The enclosure is made from 6061 Aluminum alloy. It should be mounted in a safe location, aw

MoTeC USA Installation 7 • Try to keep the antenna mounted on the centerline of the vehicle. As with normal wheel speeds, during cornering the

MoTeC USA Installation 8 Setup for ADL2 / SDL / ACL For ADL2, SDL or ACL use, please select the template “GPS - Standard RMC GGA” listed under